The functions of the catalytic burner simultaneously Purify and Fragrance the air. The heat from the burner along with the movement and mixing of air from convection of the catalytic burner Purify the Atmosphere. During this process the Parfum evaporates releasing a Fabulous lingering Fragrance.

Lamp Instructions

1. Set your Scentier™ Lamp on a level, stable surface away from any heat or flammable objects Remove the open/vented shade and solid cap.

2. Fill your Scentier™ Lamp approximately 2/3’s full with Lamp Parfum using funnel cap provided. Dry Lampe Carefully!

3. Insert the burner/wick into your Scentier™ Lamp. Carefully check to make sure burner/wick is fully inserted into Lamp neck.

4. The first time you use your Scentier™ replace the solid cap and allow the burner/wick to absorb fragrance for 20 minutes. Light the burner, leaving flame to burn for 2 minutes.

5. Blow out the flame. Your Scentier™ Lamp is now operating. Replace the open/vented shade over the burner. 25 to 45 minutes operating is sufficient for 300 sq. feet.

6. To stop your Scentier™ Lamp remove the open/vented shade from the burner. Replace the solid cap on burner. Replace open/vented shade on solid cap.

Lamp Recommendations:

Replace burner / wick assembly once a year or after every 250 uses.

When not using your Scentier™ Fragrance Lamp keep solid cap on stone to prevent the evaporation of fragrance.

Keep Scentier™ Fragrance Lamp as well as refill perfume out of the reach of Children. If swallowed seek medical attention immediately.

Perfume is highly flammable, use extreme care when handling!

If you'd like to avoid having to wait 20 minutes for your stone to soak up the fuel before lighting your lamp, try this method:

· Insert the filling funnel in the neck of the lamp as you would normally do before filling.

· Hold the stone portion of the wick assembly in the funnel as you pour Lamp Fuel over the stone and into your lamp.

· Insert the wick assembly in your lamp, light the stone, and extinguish after 2 minutes.

The fragrances used to scent catalytic lamp fuels will occasionally build up in the stone wick, clogging the wick and making it a challenge to light or stay lit. There are several easy solutions to this issue:

· Holding your filled lamp in one hand, tilt it slightly and hold the lighter flame directly on the stone for a minute or two. This is usually enough to get a good "glow" going and start the catalytic process.

· Transfer any unused fuel from your lamp back to the bottle. Replace the wick in your empty lamp and light it, letting it burn off any fragrance buildup. Remove the wick and let it dry out completely.

· Best Solution! Use Wick Cleaner (unscented fuel) to cleanse your stone wick. Soak your burner stone and wick in the cleaner solution for 30 minutes. Then place wick in an empty lamp and light. Either let it burn out completely or blow out after five minutes and then let the stone burn out all remaining residue. Or after soaking your stone as mentioned above, fill your lamp as you normally would with Wick Cleaner and light it and blow out after 4-5 minutes. The Wick Cleaner will help burn off the fragrance buildup in your stone wick.

· The best way to avoid a clogged stone is to fill your lamp with only as much fuel as you intend to burn at one time and let it burn completely out. Avoid leaving fuel in the lamp as the fragrance tends to collect in the stone when the lamp is not burning.